Posted by Ian Ellison on 10:56:59 24/05/2004:
In Reply to: Re: Kowalski torch repair ? posted by Nick Butcher on 13:56:5605/10/2004:
: There are two small grub screws holding the rear of the torch in place. They are located at the back end of the cylinder on opposite sides to each other and at 90 degrees to the handle. : You need a 2mm allen key to undo them. : The rear panel can then be prized out (carefully). : You'll need to kake sure that the o-ring seals OK when you re-assemble it, using some silicone grease. Hi Nick, Thanks for the advice, I have already fopund the grub screws, and removed them carefully, however the cover just doesn't want to come off!! should it be twisted or just pulled off straight?? Regards Ian